Page 1 of 1
cm300 corrupted? error#2411
Posted: Wed Sep 13, 2006 1:37 pm
by DPYWDN
Just tried to read a new cm300 using a AARKN4081B cable with a FKN8096A adapter in cps mode, running cps ver. 5.03.00. Cps states error #2411 - corrupted code plug.
Is my radio now dead or is this just motorola's way of telling me to update my software.
Posted: Wed Sep 13, 2006 1:57 pm
by escomm
Current CPS version is 05.05, so it's most likely the latter.
Posted: Wed Sep 13, 2006 3:30 pm
by MotoMax300
Send me the codeplug, I have the most current and will test it here as well for you.
Posted: Wed Sep 13, 2006 4:12 pm
by DPYWDN
The radio is new, never been programmed. Tried to do the first read and received the error #2411. Any suggestions?
Posted: Wed Sep 13, 2006 4:38 pm
by escomm
Yeah, get the current CPS.
Posted: Wed Sep 13, 2006 5:31 pm
by DPYWDN
Sounds right. Thanks
Posted: Fri Sep 15, 2006 11:45 am
by HLA
it's probablly not the cps, it would say codeplug too new if that was the case. are you shure you had the adaptor in normal mode and not flash mode at any time you were trying to read or write to the radio? what is the exact model number. it's possible that you can write a different codeplug into the radio and overwrite what's in it.
Posted: Fri Sep 15, 2006 11:48 am
by escomm
Actually the CP/CM series won't say that the codeplug is too new.
I had a handful CP200 and CP150 go to the depot for service and were returned with the newest firmware (3.0 I believe) and when I tried to use the old software for giggles it returned a corrupted codeplug error. Used the latest software and it read fine.
Same thing happened with some BPR40s that had the 01.01 firmware, software did not mention that the codeplug was too new and instead returned an error message about a corrupted codeplug.
Posted: Sat Sep 16, 2006 4:13 pm
by DPYWDN
Loaded up ver 5.05 and all is well again. Thanks for taking the time to reply all.