Batboard

Hi guys,

I am knw into radio programming and this might sound a stupid question. I have a 16 channel UHF Motorola HT1000 radio and the cable and also the pc. How do I program the channels? This might have been answered on previous post. Can someone please be kind and answer me?

Thanks

You need RSS (Radio Service Software), licensed from Motorola and a RIB, and you're set to go!

i do have them all, i just need the key strokes entries.

Open RSS in DOS, F3 - F3 - F10 - F4 - F5 then type them in.

thanks, i will try it tomorrow at work since i have the old pc there and will let you know

You know, I am probably a little off.

Serious note though, look at the screen when you open the program, connect the rib, then select GET CODEPLUG / READ, READ RADIO, Then Exit that screen by F10, then F4 Modify Current, F5 channel / mode configuration.

thanks

thanks, it works even with a ribless cable on windows 98

you don't realize how lucky you got that it worked in 98 but you need to take everyones advice and do it in real dos from now on before you turn that radio into a doorstop.

my buddy learned the lesson of a ribless cable too on his XTS3000 when he got "FL 01/82" once.

fortunatly i had a saved good codeplug and was able to get the radio recovered.

i have been playing with both radios for a while now and no problem so far, i am crossing my fingers

i was hoping also to program them to listen to nypd, but all the frequencies that NYPD uses are around 476MHz