STX Program Cable Part Number

dittrimd · Post by **dittrimd** » Mon Oct 16, 2006 7:51 pm

I am looking for the motorola part number for a STX programming cable.

Thanks,

Mark

RESCUE161 · Post by **RESCUE161** » Tue Oct 17, 2006 3:45 pm

There are many old speaker mics floating around. You could make your own with two mics.

Post by **xmo** » Tue Oct 17, 2006 5:22 pm

01-80357A54

MOL says item has been cancelled.

dittrimd · Post by **dittrimd** » Tue Oct 17, 2006 6:44 pm

Thanks for the info on the part number. I was sure it was cancelled but I can use the part number for additional search options. I will consider the speaker mic option just not sure how hard it would be to modify. I have made the Jedi and Genesis cables by changing the pins but this connector look a bit more difficult.

Any chance there is an after market place to buy just the connector?

Thanks

Mark

RESCUE161 · Post by **RESCUE161** » Wed Oct 18, 2006 2:04 am

No, this is by farthe easier to build as far as handhelds go, imo.

wiscomm · Post by **wiscomm** » Thu Oct 19, 2006 1:54 pm

I just listed 6 brand new STX mics on the 'bay. I might have some used that would be a good candidate for this project. PM me and I will see what have in the gaylord that just arrived.

Craig

MTS2000des · Post by **MTS2000des** » Thu Oct 19, 2006 10:18 pm

dittrimd wrote:Thanks for the info on the part number. I was sure it was cancelled but I can use the part number for additional search options. I will consider the speaker mic option just not sure how hard it would be to modify. I have made the Jedi and Genesis cables by changing the pins but this connector look a bit more difficult.

Any chance there is an after market place to buy just the connector?

Thanks

Mark

It's a VERY easy cable to build. Just move some pins around. I will check and see if I have any old STX mikes in the junk pile. FYI the STX RSS is finnicky though, it runs on this P3 800 (DOS boot disk) but won't read or write. Works fine on the ol' Thinkpad 360.