Batboard

Posted: **Fri Oct 27, 2006 3:41 pm**

i have a desktrac m/n L44SUM70D0B. what would i need to do to make this into a repeater.

i have read that the repeater ver. of the descktrac has a maxtrac without the PA. if you remove the PA how do you get power to the radio?

thanks

Posted: **Fri Oct 27, 2006 4:50 pm**

The receiver is powered thru the front connector and cable to the interface board.

You will need: the interface to radio cable 0198213606
the radio RF connector to antenna jack cable 0102712C47
the two mounting brackets, and screws

Posted: **Fri Oct 27, 2006 5:07 pm**

ok. is the board in the BASE the same as the RPTR ver.? i would prob. say no. from what i can see there is no place to plug in the RX radio.

next

is the interface to radio cable available?

i can make my own ant. cable.

thanks

Posted: **Sat Oct 28, 2006 9:06 pm**

The Front Panel Board should be the same.

I usally make my own cable from the FPB to the second receiver. However I did not use the plugin on the FPB, soldered cable direct to the FPB.

Posted: **Mon Oct 30, 2006 4:18 pm**

ok thanks. i found the desktrac service manual at work. now i can see whats what.

Batboard

desktrac base into repeater

desktrac base into repeater