Micor test set schematic needed!

k5rpd · Post by **k5rpd** » Wed Nov 29, 2006 4:26 pm

Micors- I know they are old but they are workhorses!

I am looking for the test set for the micor schematic.
I can get along ok using a simple multimeter, but the test set seems like it would follow the manual easier and be a snap to tune that way.
Thanks,
JJ

Al · Post by Al » Thu Nov 30, 2006 6:44 am

There were at least 3 different Micor test sets built....give us a part number and I or someone here may be able to help!

k5rpd · Post by **k5rpd** » Thu Nov 30, 2006 9:05 am

Looking for Model S1056 or S1059A or something of that same line or vintage.
I did find the older test set schematic on repeater builder but was hoping to find one of the newer ones.
Thanks,
JJ

k5rpd · Post by **k5rpd** » Sat Dec 02, 2006 4:57 pm

BUMP!

Anyone? The 1059 would be the best probably...

Thanks,
JJ

DJP126 · Post by **DJP126** » Sun Dec 03, 2006 8:27 pm

The 1059 would be the best probably...

Actually, the TEK-5 metering panel would be the best. It had 7 or 8 meters on it so you could see each stage of the transmitter or receiver at one glance.

Post by **xmo** » Mon Dec 04, 2006 8:05 am

The test set that was optionally installed in Micor base/repeater stations would also be a good choice.

There is one on ebay right now @ item: 280055289418

I personally would not spend a zillion hours building something that can be bought for a few bucks.

k5rpd · Post by **k5rpd** » Wed Dec 06, 2006 10:06 am

OK then- Anyone have a picture of the TEK-5 metering panel or maybe (fingers crossed) a diagram or something of the sorts?

Thanks,
JJ