Page 1 of 1
Prbolem with tk830
Posted: Mon Jan 29, 2007 3:47 pm
by mark steinmann
I know this is not a Motorola, but hopefully someone can help. I have re-programmed a tk730/830 set up, all went fine except, i have a short beep after programming and reattaching the mic, also the display flash's, i can push the group button and the beep goes off, but key the mic and the beep comes back, i programmed with KPG-7D. thanks
Posted: Mon Jan 29, 2007 3:49 pm
by tvsjr
I believe the beep indicates VCO unlock... I know a double-beep on an x90 series mobile indicates the same. Does the radio receive/transmit OK?
You might give your question a shot over on
http://www.radioinfoboard.com. More Kenwood people there.
re
Posted: Mon Jan 29, 2007 4:04 pm
by mark steinmann
no tx or rx
Posted: Tue Jan 30, 2007 8:49 am
by Splat
IIRC, tvsjr is right... vco is unlocked. It's been a while since I had my 830 setup. Check over at
http://www.radioinfoboard.com/