Batboard

I have a GM300 i just got today, and it wont power on, the guy told me it should need the igniton pin on the accessory, how do i set this up to use inside as a base? do i need to jump the pin or what do i do?

Run a wire off Pin 10 on the accessory connector to 12v+, and you're good.

Search for GM300 and Fuse. Here are some results

http://batboard.batlabs.com/viewtopic.p ... gm300+fuse

http://batboard.batlabs.com/viewtopic.p ... gm300+fuse

http://batboard.batlabs.com/viewtopic.p ... gm300+fuse

Ok i determined the radios igniton connector has to be powered, how can i turn this off?

Thanks guyz

If I remeber this is a fuse cut or trace cut on the pc board. Just hook the accessory wire to the same spot as your mail power and you will be all set. Just a lot harder to change it back.