Cdm750's as a repeater

Hardwire001 · Post by **Hardwire001** » Wed Mar 07, 2007 4:51 pm

OK, I have (what I hope) is a simeple problem....

I have two CDM750 set up with NANDS bi-directional RICK, but I am not getting the any PL out of the radio ?

I am assuming I did something wrong with the setup in the code plug... quick thoughts anyone ?

HW

Well after the drive home and a cold one, is this problem due to NOT having the RJ45 shorting plug put into the radios ?

Thanks much in advance

HW

ard099 · Post by **ard099** » Wed Mar 07, 2007 7:19 pm

Yeah, you probably just need to double check the programming of the radios, the acc pin config, and make sure you have ext mic source selected instead of flat in the acc configuration, and that pl is actually programmed into the radio on the tx side. The RJ45 shorting plug does not need to be in.

Hardwire001 · Post by **Hardwire001** » Tue Mar 13, 2007 10:24 am

The PL was programed in to the radios, and would TX the PL when I used a mic with the radio, but I got no PL with the RICK. and that just made no sense to me, I have used that RICK design ( again thanks NAND) with GM300 several times before and it worked with out any problems but with the the CDM750 no such luck...

I did get the system working when FedEX delivered the replacement IP223 ( dont ask me why they are using an IP223 for this application but that is what the customer and the sales rep came up with, and the reasons I am not clear on, but that is what they did).

The bottom line is, the system is working again, the customer is happy, the safty officer is happy, sales rep happy (and off of my back), now I can get back to fixing radios...

Thanks for you input and Help

HW