HT1250 no clock on display

arlojanis · Post by **arlojanis** » Sun Mar 18, 2007 8:00 am

I have a HT1250, Firmware R05.08.02 and CPS R06.07.04. The clock has disappeared from the display. How do I get it back?

Rayjk110 · Post by **Rayjk110** » Sun Mar 18, 2007 8:24 am

It's selectable in the radio's menu, I believe under "utilities", at least that's how mine works. Then there's an option to have the clock displayed, or not displayed.

arlojanis · Post by **arlojanis** » Sun Mar 18, 2007 9:34 am

I looked and clock is checked.

ve3nsv · Post by **ve3nsv** » Sun Mar 18, 2007 9:37 am

I believe checking the clock tab in the Utilities section of the CPS only gives you the ability to set the clock time in your Utilities section of the radio menu. I don't believe there is any way to enable or disable the clock.

arlojanis · Post by **arlojanis** » Sun Mar 18, 2007 10:38 am

Clock on display can be enabled or disabled in the utilities area of menu on radio display. I now have again.

ve3nsv · Post by **ve3nsv** » Sun Mar 18, 2007 1:57 pm

I just tested my HT1250-LS+ and it appears that unchecking the clock tab in the CPS under the Utilities Sub-Menu in the Menu Items just takes it out of the radio menu. Once you have enabled the Clock in the Sub-Menu you can use the radio menu to change the clock time and enable and / or disable the clock.

To make a long story short, you can only enable or disable clock from the radio menu and not the CPS and only if the Clock is enabled in the radios Utilities Menu. This is with CPS R06.06.00 with Firmware R05.11.05.