Page 1 of 1
ht1250ls+
Posted: Thu Mar 22, 2007 5:22 am
by kc2fht
I appologize if this is a stupid queetion, but does the ht1250ls+ suport MDC Signaling? Just purchased 3, and the shop states they do not suport MDC. It is the 16 ch Limited keypad. Thanks
Posted: Thu Mar 22, 2007 6:42 am
by MTS2000des
the 1250 LS+ we have support MDC, but only on LTR modes (read=no MDC on conventional but MDC on trunking...go figure)
Posted: Thu Mar 22, 2007 6:48 am
by kc2fht
MTS2000des wrote:the 1250 LS+ we have support MDC, but only on LTR modes (read=no MDC on conventional but MDC on trunking...go figure)
Thanks that explains it.
Posted: Mon Mar 26, 2007 8:35 am
by 911-EMT
I have programmed a lot of the ht1250-ls and had no problem with mdc on conventional mode, I am not shore about the ht1250-ls+
Posted: Mon Mar 26, 2007 8:40 am
by kc2fht
seems like it is the 16ch limited keypad only. Of cours the ones we ordered. Thanks
Posted: Mon Mar 26, 2007 1:33 pm
by wavetar
Lots of information on the subject in the knowledge base:
http://batboard.batlabs.com/kb.php?mode=article&k=35
Todd