Page 1 of 1
OT: M/A Com Jaguar 700 help
Posted: Mon Mar 26, 2007 1:53 pm
by otter9309
I know this is a little OT, but I am looking for the pin-out for the Jaguar connector. I am wanting to have a RICK cable made to interface to the XTS series.
TIA
Steve
Posted: Fri Mar 30, 2007 6:39 pm
by Elroy Jetson
Posted: Sat Mar 31, 2007 7:09 am
by otter9309
Thank you sir, and welcome back.
S.
Posted: Sat Mar 31, 2007 8:51 am
by Elroy Jetson
I realize this doesn't tell you the FUNCTION of each and every line, but it's a start. And if I can dig it up, I found a site that hosts many of the ericsson/ge service manuals. (LBIs) I'll give you the link when/if I find it.
Posted: Sun Apr 01, 2007 3:55 pm
by Elroy Jetson
As I said, I'd give you the link when I found it. Here it is.
http://www.repeater-builder.com/ge/lbi-master-list.html
MANY GE radio manuals are listed here.
I BELIEVE that the M-RK shares the same accessory connector and programming cable as the LPE and Jaguar portables. This suggests that if you can find the full pinout for ONE of them in those manuals, you've got the pinout for the others as well.
Elroy
Posted: Mon Apr 02, 2007 2:38 am
by 5-sides
For a P7100, which should be the same pin-out:
E1--Rx Data
E2--Emer UDC B
E3--12V in Flash
E4--Ext Mic In
E5--Mute Out
E6--UDC Tx B
E7--Sw A+ Out
E8--UDC Sense
E9--UDC Audio
E10-GND
E11-Tx Data In
E12-PTT UDC B
MM101334V1 Rev B,
Feb-04 pg25 fig 6-6
Posted: Mon Apr 02, 2007 4:39 am
by otter9309
Thanks again for all the help.
Steve
