Batboard

Hi!

I have VHF GM900 that I can programm and RX is also O.K.
But when I press PTT it starts to beep continously and green an red LED are flashing. If I push buttons it returns to normal RX.
Any idea ?

It looks like the PLL do not lock.
Did you programmed the radio out of the bandsplit?

Andreas

Hi!

It is programmed from 145 to 170 MHz same think on any frequency.

Write your tuning parameters down and program the radio with a default codeplug,but I think you have a hardware problem in the PLL part of the radio.

I can give you a default codeplug and you only have to load it with
MTSX-Lab into the radio.After this retune the radio with the old parameters.

Andreas