Systems Saber securenet issues

[NSPD]

I recently installed an NTN5833A module in my VHF Systems Saber III (replaced the bypass module). After the swap I turned the radio on and it worked normally. I then went into the RSS and turned on securenet, wrote to the radio, and now in both Clear and Secure modes I can key up and the TX light will come on, and then the radio will make a solid tone. The radio will not TX or RX at all. What do I need to do to fix this?

[6V6GT]

Is the radio set as "strapped" in encode mode? It will ignore the encrypt/clear switch if so and won't transmit without a key...


Tim

[NSPD]

I don't think it is strapped. I could flip the secure switch and the icons would change but no TX or RX at all.

[RADIO43]

Sounds like you are having the same problems as I am.....

See the forum I started - http://batboard.batlabs.com/viewtopic.php?f=1&t=71756

1 Radio has a By-pass module and 1 had a DES Board..


Radio keys up and then I get a steady tone. This is with the securenet disabled.....

[N9LLO]

See if it was modified for Fasinator encryption. Look for added wiring on the back of the main board.

Chris
N9LLO

[bellersley]

Is this the radio you got from unlisted? If that's the case, it wasn't modified for Facinator. I had one that came from the same source and it worked just fine.

[RADIO43]

Neither of my radios were from unlisted but I did notice a extra wire on the back of the Controller board. It runs from the area of the securenet board to the top of the board. Is this my problem????

[NSPD]

I didn't notice any extra wires for Fascinator, and both my radios did come from unlisted. I turned off encryption in the RSS and it's working fine again. Just a minor irritant since I would like to have DES running in this radio.