Hi Guys,
I am trying to set up a single channel IR. I have a Quantar with the proper firmware etc. I programmed it but after the station reset it did nothing, no site trunking, no nothing. This si not connected to any kind of controller, its just in a rack by itself.
What are the key things in setting this up? I am using the "voice on control channel" feature.
Thanks.
Single Channel InteliRepeater
Moderator: Queue Moderator
-
Dan562
- Posts: 533
- Joined: Mon Aug 23, 2004 7:30 pm
- What radios do you own?: Kenwood, Yaesu, ICOM, Motorola
Re: Single Channel InteliRepeater
Perhaps it's impossible to have a Single Channel IntelliRepeater. I always though you would need to purchase two stations so the configuration performs correctly. To my way of thinking, it would be like ordering a one receiver comparator, "What's it going to compare too?"
Dan
Dan
-
Batwings21
- Posts: 930
- Joined: Fri Jun 23, 2006 11:21 am
Re: Single Channel InteliRepeater
I've never heard of that feature, but I still say you need 2 channels.GEMOTO wrote: What are the key things in setting this up? I am using the "voice on control channel" feature.
Thanks.
Re: Single Channel InteliRepeater
Ok, thanks guys. Any tips/trickd on setting up a two channel system?