Question on the building of the ht1250 programming cable

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
firetruck1
New User
Posts: 12
Joined: Tue Feb 12, 2008 6:22 am
What radios do you own?: XLS2500 HT1550 XLS EX600

Question on the building of the ht1250 programming cable

Post by firetruck1 »

I'm building a programming/flash cable using the schematic from batlabs. My question is pin 3 on p1 doesn't go anywhere. but I have a after market cable that has pin 3 being used but there is no boot control(pin 25) thats why I building my own. Do I need to connect this pin?
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”