Page 1 of 1
R1225 Front Panel Pins
Posted: Wed May 14, 2008 12:48 pm
by Mikey
I have an R1225 Repeater but don't have the Dashboard for it. What Pins do i jump on the front of the radio where the dashboard Ribbon Cable Connects to make the radio Power up?? I read that you can operate the repeater without the dashboard if you jump the turnon pins together.
Mike
Re: R1225 Front Panel Pins
Posted: Fri May 16, 2008 2:46 pm
by Will
J8 a 15 pin male connector is on the front with pin 1 under the receiver RF jack.
On J8, pin 8 is battery/13 volts. Pin 7 is switched A+/battery/13 volts. Jumper these two pins with a Berg jumper, like used on computer motherboards.
Re: R1225 Front Panel Pins
Posted: Fri May 16, 2008 8:21 pm
by Mikey
Do i have to jumper any of the pins to enable "Repeat" or just the power pins?
Re: R1225 Front Panel Pins
Posted: Fri May 16, 2008 11:30 pm
by Will
Just the power pins.