HLN6412A (MCS2k dual head accessory connector)

This forum is dedicated to helping people with questions about installing radio equipment in vehicles. This can include antenna installs, electrical wiring questions/problems, and mounting systems. Pictures of installs are welcome.

Note: Discussions regarding lighting, sirens, and other equipment now has its own forum in the 'off-topic' section below.

Moderator: Queue Moderator

Post Reply
thebigphish
Posts: 1477
Joined: Sat Nov 29, 2003 10:10 pm
What radios do you own?: AM/FM

HLN6412A (MCS2k dual head accessory connector)

Post by thebigphish »

I have an HLN6412A for a MCS2000 dual head installation, and the accessory connector was disconnected and one of the pins pulled out of the accessory connector, and i can't tell where it goes. I've looked @ all the (limited) MCS2000 installation stuff, and the programming connections, and i have a yellow wire which has a female pin end for the accessory connector that i can't identify. I've identified and confirmed pins 1,2,4 -> 9,10,11, 14 on the connector, but still have this yellow wire doing nothing which obviously belongs somewhere. Any ideas?
"How do you plan to outwit Death?"
"With a knight and bishop combination; I will destroy his flank." --Antonious Block
Top
thebigphish
Posts: 1477
Joined: Sat Nov 29, 2003 10:10 pm
What radios do you own?: AM/FM

Re: HLN6412A (MCS2k dual head accessory connector)

Post by thebigphish »

....and we can close this one, it's switched B+ which drives the amplified speaker in the setup. Connects to pin 14 on the accessory connection. Thanks for looking.
"How do you plan to outwit Death?"
"With a knight and bishop combination; I will destroy his flank." --Antonious Block
Top
Post Reply

Return to “Vehicle Radio Installs”