Kenwood TK-360G Radio - Programming Out of Band?

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Locked
User avatar
losangelescop
Posts: 153
Joined: Fri Jun 23, 2006 3:28 am

Kenwood TK-360G Radio - Programming Out of Band?

Post by losangelescop »

Hi all,

Probably a long shot, but does anyone know if it is possible to program Kenwood radios, specifically the TK-360G out of band at all?

Bandsplit ends at 470 MHz, however I wish to make it go to 480MHz.

Thanks people!!
Motorola, Federal Signal and the MX7000 RULE!
Top
User avatar
n7maq
Posts: 1440
Joined: Tue Nov 27, 2001 4:00 pm
What radios do you own?: Mocom 70 w/scan!!

Re: Kenwood TK-360G Radio - Programming Out of Band?

Post by n7maq »

losangelescop wrote:Hi all,

Probably a long shot, but does anyone know if it is possible to program Kenwood radios, specifically the TK-360G out of band at all?

Bandsplit ends at 470 MHz, however I wish to make it go to 480MHz.

Thanks people!!

The software will take and program the out of band freq. The software may give you a warning, but it will take it. Now if the VCO locks is another question. If it does not, you should be able to adjust it. I have used 450 to 470 360G's in the ham band with no problem or adjustment.


Jim
Top
Locked

Return to “General Motorola Solutions & Legacy Radio Discussion”