MSF 5000 DTMF Encoder/Decoder Programming Help

This forum is for discussions regarding System Infrastructure and Related Equipment. This includes but is not limited to repeaters, base stations, consoles, voters, Voice over IP, system design and implementation, and other related topics.

Moderator: Queue Moderator

Post Reply
User avatar
d119
Posts: 3538
Joined: Tue Mar 19, 2002 4:00 pm

MSF 5000 DTMF Encoder/Decoder Programming Help

Post by d119 »

Anyone familiar with the QRN8800A and TRN9754A MSF 5000 DTMF Encoder/Decoder and Wild Card module?

I removed this off a customer's repeater today as it was causing problems with not allowing in-cabinet repeat. They originally used it for remote setup/knockdown of the repeater OTA with DTMF.

They said they were going to throw it out and that I could have it if I wanted it, so I obliged. They didn't remember the commands for it.

I would like to use it on another MSF 5000 for remote setup/knockdown. The DTMF Encoder/Decoder module has three LED's: Program, Decode and Encode. There is a 6-conductor RJ-type jack on the front of it labeled "Program", and it looks exactly like the "Control" jack on an MSF SSCB.

Anyone know how this is programmed? Is there special software, or ? Any information would be appreciated. Thanks!
Top
com501
Posts: 1088
Joined: Fri Nov 02, 2001 4:00 pm
What radios do you own?: Over 50 - All Motorola

Re: MSF 5000 DTMF Encoder/Decoder Programming Help

Post by com501 »

Bump

I also need to know how to program these. Can't find a manual anywhere.

Any suggestions?
Top
Post Reply

Return to “Base Stations, Repeaters, General Infrastructure”