Power amp connector
Posted: Sat Aug 08, 2009 12:56 am
Hi guys,
I recently bought a TPL power amp - a PA6 - which is the same type that is Motorola OEM'd with the XTVA kits. Problem i've got is that the power connector is shagged. two peices of light duty 9-volt snap on type wire have been glued into te back oif the connector, and filled with silicone sealant, a cable tie placed around it to hold it together, and then covered in heatshrink to make it look ok.
Obviously I need to source a replacement - any ideas, apart from Motorola, where I can get these babies from?
Cheers,
Matt
I recently bought a TPL power amp - a PA6 - which is the same type that is Motorola OEM'd with the XTVA kits. Problem i've got is that the power connector is shagged. two peices of light duty 9-volt snap on type wire have been glued into te back oif the connector, and filled with silicone sealant, a cable tie placed around it to hold it together, and then covered in heatshrink to make it look ok.
Obviously I need to source a replacement - any ideas, apart from Motorola, where I can get these babies from?
Cheers,
Matt
