SQUELCH

[elmanoduarte]

Hi

Can we in RSS control the squelch in a GM-300 ??

Thanks

[Bill_G]

Working from memory, it should be under service - alignment - squelch.

Unless your question is about AND/OR sq. That should be under Radio wide - mode, but do not recall if it is selectable or not.

[Josh]

Working from memory, it should be under service - alignment - squelch.

Unless your question is about AND/OR sq. That should be under Radio wide - mode, but do not recall if it is selectable or not.

Coarse squelch is adjusted from a blue pot on the RF board in the radio, as I recall.. it's marked with an 'SQ'.

-Josh

[AEC]

Josh is correct, the fine tune adjustment is softpot controlled, with the coarse tuning done via board mounted pot on the RF board, near the receiver IC and board interconnect header.

[Bill_G]

Oh yeah. Forgot about that one.

[elmanoduarte]

oK, MANY THANKS ALL, i found the blue pot on the RF board , the SQ , alredy maked a small correction, it´s better now.
About under service - alignment - squelch, theres NO squelch on Aligment MENU , theres WARP and TX aligments, NO squelch , are you shure about that ?
About ... " Josh is correct, the fine tune adjustment is softpot controlled, with the coarse tuning done via board mounted pot on the RF board, near the receiver IC and board interconnect header."
..Is this the the blue pot SQ what you mean ? ,,or theres anothere for More Fine Tuning ?

thanks

[Bill_G]

No. The blue pot is THE sq control. I was wrong. After you service a few hundred, all the radios become just another pretty face. Hard to remember exactly everything about every model.

[elmanoduarte]

ok , many thanks