APX7000 out of band

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
cinder
New User
Posts: 6
Joined: Fri May 16, 2008 7:50 pm

APX7000 out of band

Post by cinder »

I have a 380-470 split and I would like to go out of band a bit higher. How can I do this?
Top
User avatar
escomm
Queue Moderator
Posts: 5170
Joined: Fri Mar 24, 2006 8:24 pm

APX7000 Out of band

Post by escomm »

Has it been done?
Top
User avatar
n7maq
Posts: 1440
Joined: Tue Nov 27, 2001 4:00 pm
What radios do you own?: Mocom 70 w/scan!!

Re: APX7000 out of band

Post by n7maq »

In the radio information window with expert view enabled there is a tab called "Frequency Ranges" if you open that up you can select "allow invalid frequencies". We tested this with a V/U (R1) by enabling UHF R2, then entering frequencies from 470.025, to up above 500.00MHz. Well the radio did not like it as soon as one of the out of band channels was selected, it just gave an error tone and displayed a message about RX freq error.

Jim
Top
Post Reply

Return to “Radio Programming”