Batboard

I came across one of these that was used to control a Whelen Edge. I have one on my truck which is why i got it. Does anyone have a wiring diagram for this unit? Do I need the Maratrac sirem controller to use it? ANY help appreciated

I think that one is just low current switches that control low level circuits in the Whelen or external relays.

Will,

You are correct. The switches - on-off and momentary - are rated at 1 amp or less. The can be confingured as either NO or NC depending on which pin you choose. I have one of these to control my strobe pack and LEDS. I just got some small 12vdc 10 amp relays and went to town with a Radio Shack project box. Works / looks outstanding and the relay box is tiny and tucked under the dash.

Jim

How close would that be to an HLN1196B? An ohmeter to the connector pins could tell easily.

http://dl.dropbox.com/u/2991846/HLN1196B.pdf