Page 1 of 1
HT1000 Dead LED
Posted: Wed Jul 14, 2010 7:25 pm
by maxkelley_kc2spy
I have an HT1000 that has a seemingly dead LED... No light up on power-on, RX, TX, and scan program (what the user needs!). Think it's as simple as a dead LED, or is this part of a bigger problem?
Re: HT1000 Dead LED
Posted: Thu Jul 15, 2010 8:15 am
by Will
Check your programming, there is an option to disable the LED.
Re: HT1000 Dead LED
Posted: Thu Jul 15, 2010 3:53 pm
by maxkelley_kc2spy
Checked that, turned out to be a bad flex... Very brittle plastic connectors, too! The insertion levers for the flex on those plastic connectors actually broke in half when trying to remove them.
Re: HT1000 Dead LED
Posted: Thu Jul 15, 2010 9:22 pm
by kotaguchi
No.I think the above person meant to check in the RSS software.In the programming software,there is a option to disable the LED.
Re: HT1000 Dead LED
Posted: Fri Jul 16, 2010 3:55 am
by maxkelley_kc2spy
Yeah, I realize that, and checked it in the RSS. The LED was enabled on receive, TX, and for low battery warnings, and showed on none of them. However, when I opened the radio, I saw that the flex was beginning to rip, and had some corroded pads. I'm thinking it's probably the latter that caused it
