CM300's Used As A Repeater

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
frakertw
New User
Posts: 8
Joined: Mon Dec 07, 2009 1:38 pm

CM300's Used As A Repeater

Post by frakertw »

I need help configuring two CM300's as a Repeater. I noticed a post from 4 years ago addressing this but didn't see a resolution. I built the simple repeater interface cable that I found on this side using a 4.7K pot, 1.5K resistor and a 2.2uv cap. The problem is that the TX radio stays keyed up when it receives PL. I had two PM400 radios and the cable works fine. Does anyone have a solution?
Top
User avatar
Bill_G
Posts: 3087
Joined: Thu Sep 17, 2009 5:00 am

Re: CM300's Used As A Repeater

Post by Bill_G »

Did you see this thread discussing problems with the COR line?

http://batboard.batlabs.com/viewtopic.p ... er#p322485
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”