I have an MTS2000 III flashport that was programmed with DOS software by the previous owner. I do NOT have DOS but windows based software for the same radio. Will I have problems trying to program it or no?
Manny
DOS Vs. Windows Question
Moderator: Queue Moderator
Re: DOS Vs. Windows Question
No problems. It should work
-
HLA
- Posts: 2334
- Joined: Mon Jul 11, 2005 8:15 pm
- What radios do you own?: HT1550's, X9000's, CDM1550's
Re: DOS Vs. Windows Question
The windows cps will work fine but you won't be able to go back to the dos version without a saved codeplug
HLA
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
-
Victor Xray
- Posts: 845
- Joined: Mon Dec 17, 2001 4:00 pm
Re: DOS Vs. Windows Question
It depends on the firmware version and/or controller size in the radio. Some controllers with firmware R05.x and below can read with Windows CPS but they won't write.