Batboard

Hi!
I connected GLN1052 from dead McMicro to M110. It is working O.K. but I can change channels in one direction only.
All buttons are working except the "house" button. I do not have the manual for GLN1052 so I don´t know if this button is for "CH UP" or not ?

sb wrote:Hi!
I connected GLN1052 from dead McMicro to M110. It is working O.K. but I can change channels in one direction only.
All buttons are working except the "house" button. I do not have the manual for GLN1052 so I don´t know if this button is for "CH UP" or not ?

By any chance have you looked at the programming to see how the mic buttons are set up? Some of them I believe can be changed to different functions in the software.

Jim

Hi!
Found the manual of Storno CQM5500 which is the the same radio. I have the SELECT 5 radio so it is only one button for channel select.