Batboard

In playing with my GM300, I can't quite figure out where to put the IDs to decode. I'm using the V5 RSS.

Any help would be appreciated, please.

Thanks!

you don't, where is it going to display it at even if it could?

HLA wrote:you don't, where is it going to display it at even if it could?

On my beautiful 2 digit display.

I was under the impression that this unit could decode MDC and as long as the ID you wanted to receive was in a call list, you could assign it a 2 digit alias to display. When receiving MDC now, it displays 00, which according to other posts, indicates that the ID received has been decoded and isn't in the "alias" list.

Again, any help?

'Call list Configuration'...from Main Menu press 'F4'-->'F9'. Press 'F8' to add and then define each call list member.

wavetar wrote:'Call list Configuration'...from Main Menu press 'F4'-->'F9'. Press 'F8' to add and then define each call list member.

Worked like a charm. Thanks!!!