Fellow Forum Members,
Looking for anyone who has sucessfully interfaced a tone panal to a Quantar. I'd like to put my Zetron 38A on this repeater before putting it into service.
Thank you in advance,
Larry
[tone panel on a quantar]
Moderator: Queue Moderator
[tone panel on a quantar]
Someday We'll Look Back On This And It Will All Seem Funny.
From Rosilitia, Sung By Bruce Springsteen, CIRCA 1973
From Rosilitia, Sung By Bruce Springsteen, CIRCA 1973
-
Motoboy
- Posts: 102
- Joined: Wed Nov 11, 2009 1:58 pm
- What radios do you own?: HT1250 I saved from the dump
Re: [tone panel on a quantar]
If you're looking to use it as a community repeater, see this thread:
http://batboard.batlabs.com/viewtopic.php?f=10&t=95517
If you are using it to count PL's, a simple connection to the discriminator audio and COR should be all that is needed.
http://batboard.batlabs.com/viewtopic.php?f=10&t=95517
If you are using it to count PL's, a simple connection to the discriminator audio and COR should be all that is needed.
"I don't have a driver's license, either, and that never got me in trouble!" ~Customer
Re: [tone panel on a quantar]
The full-size Quantar maintenance manual has a whole chapter on this subject. In general (and from memory), you have to make some electrical connections and you need to do some wildcard programming to set up the required audio paths at start up. (Don't forget to specify both cold and warm starts.)