I have a dual-head UHF PM1500. I am getting a "ID # ERR" on the front control head. (The rear head is working normally.) I am using a known good codeplug that was cloned into the radio. The truck the codeplug came from works fine. I have checked all the programing options that I know off, they all look good. Any ideas?
Thanks.
ID # ERR on a Dual-head PM1500
Moderator: Queue Moderator
Re: ID # ERR on a Dual-head PM1500
Try this:
Power the system down. At the affected head, hold down the orange button + the last soft key then power up the radio. You should then be able to change the control head ID #. The main head should be set to 1, the auxiliary head set to 2.
Should work properly after you've corrected this issue.
Power the system down. At the affected head, hold down the orange button + the last soft key then power up the radio. You should then be able to change the control head ID #. The main head should be set to 1, the auxiliary head set to 2.
Should work properly after you've corrected this issue.
Re: ID # ERR on a Dual-head PM1500
Thanks!
That was it!
That was it!
Re: ID # ERR on a Dual-head PM1500
Excellent! You're most welcome, always glad to help.