Help with MT1000 99 chan program

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
LP21
Posts: 1
Joined: Fri Dec 23, 2005 6:23 pm

Help with MT1000 99 chan program

Post by LP21 »

Have several 99 channel low band (33mhz) MT1000's. After programming I find that two units always revert back to channel one when turned off and then back on. Several other units will turn back on the same channel they were turned off. This company wants the radios to power back up on the same channel they were on when turned off. Is this a software issue or is there something I am missing?
Top
User avatar
MTS2000des
Posts: 3347
Joined: Sat Jan 04, 2003 4:59 pm
What radios do you own?: XTS2500, XTS5000, and MTS2000

Re: Help with MT1000 99 chan program

Post by MTS2000des »

IIRC there is a setting in RSS under radio wide options, but I think it depends on the radios' firmware to support it. Been a while since I maintained some of these, but the older controllers (AN version model numbers?) didn't support power up on last channel used.
The views here are my own and do not represent those of anyone else or the company, the boss, his wife, his dog or distant relatives.
Top
Post Reply

Return to “Radio Programming”