GP2000 goes into CLONE at turn-on

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
K6ncx
New User
Posts: 3
Joined: Thu Apr 21, 2011 3:38 pm

GP2000 goes into CLONE at turn-on

Post by K6ncx »

I have a (UHF, not that that should matter) GP2000 which has been working fine. But today when I turn it on it displays CLONE and then in a few seconds TIME OUT. There is nothing connected to it. I have done a factory reset on it, which changs nothing. Any ideas?

Just in case somehow it's bizarrely related, I'll not a couple of quirks this radio had before: PL tones could be set only by number, not by frequency, and DPL was not available.
Top
User avatar
d119
Posts: 3538
Joined: Tue Mar 19, 2002 4:00 pm

Re: GP2000 goes into CLONE at turn-on

Post by d119 »

Is it possible something got into the contacts in the speaker/mic connector, and it thinks a cloning cable has been inserted?
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”