Ignition control on an M120?

601 · Post by **601** » Sun Oct 19, 2003 9:36 am

I want to hook up an M120 in a vehicle, but I would like to have the radio turn on only when the car is in the accessory or run position. I looked up the pinout showing pin 10 as the control for it, or so I think? In the buses at the company I work for, the CDM1550LS+'s have this with only one wire. Is it the same for the M120? This is a 16 pin radio.

FMROB · Post by **FMROB** » Sun Oct 19, 2003 9:53 am

Yup, the main power lead needs constant power and pin 10 gets switched ignition....And your off..

Nand · Post by **Nand** » Sun Oct 19, 2003 11:10 am

And the internal pico fuse needs to be removed. Make sure to use a small fuse in the ignition control line instead.

Nand.