CM200 MOBILE PROGRAMMING CABLE

itjisfo · Post by **itjisfo** » Tue Dec 16, 2003 7:53 am

DOES ANYBODY KNOW THE PINOUT FOR THE CM200 PROGRAMMING CABLE !!!!!! THANKS FOR YOUR HELP

Znarx · Post by **Znarx** » Tue Dec 16, 2003 8:37 am

the CM/PM seres of mobiles program through the 16 pin accessory connector on the rear of the radio

data - pin #6

ground - pin #7

all you need to do is use your regular mobile cable, plug it into a modular telco box (8 pin) and use an accessory plug

....Z

RINZY50671 · Post by **RINZY50671** » Mon Nov 21, 2005 10:20 pm

"all you need to do is use your regular mobile cable, plug it into a modular telco box (8 pin) and use an accessory plug"

Trying to make a CM300 Cable. But I do not understand the above. Please help.

Nand · Post by **Nand** » Tue Nov 22, 2005 4:25 am

The cable is the same as the Maxtrac or GM300 and other Radius mobile cables with a jumper added at the radio end of the cable between the pin 1 and pin 3 of the RJ45.

Pin 1 would be the top pin when plugged in a Maxtrac with the RJ45 clip to the right in this example. Some call this pin 8.

http://batboard.batlabs.com/viewtopic.php?t=51120

Nand.