MT1000 Error 006

apco25 · Post by **apco25** » Sun Mar 21, 2004 8:48 pm

MDC-ID front - reads fine, can't program it and gives error #006

This is the same software we've always used at the county and now it won't talk to the front covers and it used to in the past???? Normal read/write works fine.

What gives?

KG6EAQ · Post by **KG6EAQ** » Sun Mar 21, 2004 10:20 pm

Might be talking out of my butt here since if you've done it before and nothing has changed it should work... but have you put the RSS on a different computer? I've heard that to program the ID front's you need to use a slower computer (Just like the x9000's when you put a MDC board in). Just an idea..

kc2dla · Post by **kc2dla** » Mon Mar 22, 2004 6:11 am

Could the cover have been swapped from another radio perhaps? I experienced the same problem you are having after I installed my MDC cover on an MT1000 that did not support it. Here are the details:

http://batboard.batlabs.com/viewtopic.php?t=20993

If you would like I can look up the model of the cover you have to see if it should work properly on the MT1000 model you are using it with.

Paul

apco25 · Post by **apco25** » Mon Mar 22, 2004 7:48 am

Ok in better detail

the platform has programmed the MT1000's before with and without ID fronts.

The particular front is NTN5457C and another radio that has the MDC/ManDown/DTMF full blown front (its not here for a part #) there is also a MDC non man down front floating around too.

I do not believe its a version issue as all these radios should be BN or later models and the covers are working right now.

I just can't change anything.

I find it really bizzare they read but fail the write.