READ ONLY Frequency range???

cfdeng3 · Post by **cfdeng3** » Tue Mar 26, 2002 10:07 am

I was programming a CDM1250 and after spending several hours updating and adding stuff I went to write to the radio. When I did that it came up with an error saying the radio freq is different from the program. I looked and in the program the frequencies read 449.995-519.995 instead of 450-520. Can anyone tell me is something corrupt?? Can I fix this??

<font size=-1>[ This Message was edited by: cfdeng3 on 2002-03-27 08:36 ]</font>

<font size=-1>[ This Message was edited by: cfdeng3 on 2002-03-28 11:55 ]</font>

Al · Post by Al » Tue Mar 26, 2002 6:55 pm

I had the same thing happen after creating 55 personalities on an HT1250...VHF radio bandsplit was 136-174 Mhz, and RSS said it was 135.995000 - 173.995000, so wouldn't allow the codeplug write to the HT.
My guess was that the frequency range stored in the codeplug file was in floating point format vice integer, and then I tried to find exactly where it was stored, and didn't have much luck.

cfdeng3 · Post by **cfdeng3** » Tue Mar 26, 2002 8:15 pm

I Just spent hours entering all the info again and the same exact thing happenned!!!!! If anyone knows a way to fix this or what is causing it please let us know.

thanks

Post by **wavetar** » Wed Mar 27, 2002 6:25 pm

Try just adding say 5-10 channels at a time, writing to the radio as you go. It may not happen that way, or if it does, at least you'll narrow it down as to what exactly is doing it.

Todd

cfdeng3 · Post by **cfdeng3** » Wed Mar 27, 2002 8:56 pm

The last time I put in all the channels and was just checking off some features when it happenned. Well I am gonna start from scratch again tomorrow.