Saber Programming Cable

Du Comm · Post by **Du Comm** » Thu Mar 28, 2002 3:42 pm

Hi there.
On your pix of both astro/saber cables it shows that you need to connect DB25 (1) to a ground on the cable end that connects to the radio. I have an old mic cord and there are 3 contacts above the 12 that are at the bottom. 1 is for the RF (3 small pins), 1 holds the connector together (phillips head), and 1 is the screw that connects the cable to the radio. Which one do I use?

Thanks/
Steve.

Monty · Post by **Monty** » Fri Mar 29, 2002 7:44 am

HI:

With resects to the Saber Plug , the outer
Contacts are the Grounds, and the Center
is the main RF I/O port:

<h3>Ground==>( o )<==Ground
========+===========
======= RF==========

[ This Message was edited by: [email protected] on 2002-03-29 10:45 ]