i am delving into some new territory here.
based on my mounting position needed for my VHF and UHF W3, i will not need the Y cable since the radios will be mounted essentially directly under the mounting location for the mic.
does anyone know if the W3 will work with a standard spectra grey accessory connector (for ignition sense and speaker audio) plugged in to the rear of the unit and the mic plugged directly into the front of the radio?
in other words, will the above work WITHOUT the Y cable... ?
doug
w3 installation question
Moderator: Queue Moderator
w3 installation question
BRAVO MIKE JULIET ALPHA
"You can do whatever you want, there are just consequences..."
IF SOMEONE PM'S YOU - HAVE THE COURTESY TO REPLY.
"You can do whatever you want, there are just consequences..."
IF SOMEONE PM'S YOU - HAVE THE COURTESY TO REPLY.
-
The Pager Geek
- Posts: 1250
- Joined: Fri Jun 21, 2002 10:31 pm
- What radios do you own?: Disney FRS
Yes they work fine without it provided you have the accessory cable in the back of the radio.
They also work fine using a standard computer serial cable with the accessory cable in the radio. This not only saves money but is easier to install in some vehicles or situations where the length of the 'Y' cable is an issue.
They also work fine using a standard computer serial cable with the accessory cable in the radio. This not only saves money but is easier to install in some vehicles or situations where the length of the 'Y' cable is an issue.