ht1000 programming cable

sealgz · Post by **sealgz** » Wed Mar 23, 2005 5:38 pm

dear guys ,last night i made a ht1000 programming cable with the pinout from batlabs, but with this pinout the cable can not communicate between the radio and computer, i load up the image see who can help me to find out problem of the pin position thanks

n7maq · Post by **n7maq** » Wed Mar 23, 2005 5:47 pm

The one posted on Batlabs is correct. Have you programmed other Motorola radios that use RSS (not CPS) with this computer? If not, read the Motorola Programming Primer on Batlabs. If you have used the computer with other RSS, then look at the cable. If you moved any of the pins on the radio connector, check to alingment of them.

Good luck,

Jim.

fire_master_21 · Post by **fire_master_21** » Wed Mar 23, 2005 5:52 pm

make sure your in DOS and not a DOS window. Are you using a cheap ebay rib? Is the battery fully charged in the radio and rib? make sure the conections are are clean.

sealgz · Post by **sealgz** » Wed Mar 23, 2005 6:10 pm

i have use same computer and same rib(original big M) and programming my saber and it's fine so i did not know what happen and i try to load up a pin image but failed, and i also try to connected the radio with pin directly for make sure the pin can contact radio but also failed

kf4sqb · Post by **kf4sqb** » Wed Mar 23, 2005 6:52 pm

Possibly just a shot in the dark, but did you remember to jumper pins 4 & 11 on the RIB end of the cable?

sealgz · Post by **sealgz** » Wed Mar 23, 2005 7:07 pm

yes, also did it, and the rss also can write my visar

n2knc · Post by **n2knc** » Tue Apr 12, 2005 5:18 pm

on mine i have the sandy style rib,and for some reason it has to be set on the rj 45 side,even if im useing the db 25 pin connector .may be good info if its not the problem in your case

N2KNC