XTS-5000
Moderator: Queue Moderator
XTS-5000
How do I tell if a Model I has a DES chip in it?
How do you take one apart?
How do you install a DES chip?
Thanks for the help.
How do you take one apart?
How do you install a DES chip?
Thanks for the help.
Check batdude's (Doug's) tutorial stickied at the top of the astro forum for instructions on how to open up your radio and locate the encryption module.
http://batboard.batlabs.com/viewtopic.php?t=61128
http://batboard.batlabs.com/viewtopic.php?t=61128
I dont have the CPS in front of me right now - I can check when I get home - but i believe if you check off "secure hardware equipped" in the CPS and then program and reread it will show you the module information in the radio information screen.aenigma wrote:Thank you.
Now the next question...
How do I tell if a Model I has an encryption module in it without taking it apart???
If not... there is always the tell-tale "somethingis wrong" *BOOP* you will get instead of the "all is well" *BEEP* when power it on. You will get the *BOOP* if there is no module installed b/c the radio is looking for one and gives and error when it does not find one. Al;ternatively, if there is a module present but no key loaded you may get a series of *BEEPs* indicating a Key Failure.
Keep in mind that I think in most radios - in order for the radio to even see the secure module (present or not) you MUST flip on secure so that the radio runs the code subroutines in order to actually query the module. The radio otherwise has no reason to concern itself with secure unless it's flagged as being present.
-Alex
-Alex
MTS2000s and XTS3000s will go looking for the module at power up. Errors will pop up at this time if it can't talk to it. It will error out again if you flip to secure, and it'll bonk if you try transmitting.alex wrote:Keep in mind that I think in most radios - in order for the radio to even see the secure module (present or not) you MUST flip on secure so that the radio runs the code subroutines in order to actually query the module. The radio otherwise has no reason to concern itself with secure unless it's flagged as being present.
-Alex
What he's referring to the multikey option bits in the flashcode:
What mike m was trying to say was if the radio has factory tags, and the flashcode indicates either H869 or H868, then there's a good chance that the radio is secure hardware equipped.
As always, the best practice is to disassemble the radio and verify the physical presence of an encryption board, and look up the board part # to verify the crypto algo's loaded.
As you can see, the bits in the 11 digit (or second digit from the left) of the flashcode, contain the multikey options. If the 11 digit is 8 (indicating just B4 is active) or 4 (indicating just B3 is active), then the flashcode has the multikey option turned on.D11 B1 - H101/G101/H169 Analog/Conventional Only Repeater Access (MDC1200/Singletone)
D11 B2 - H451 GE STAR Signalling / Q52 FPP Government Subscriber (XTS2500/5000 Only)
D11 B3 - H869/W969 Hardware Multikey Operation
D11 B4 - H868/W298 Hardware Multikey Operation & MDC OTAR (Analog/Conventional)
What mike m was trying to say was if the radio has factory tags, and the flashcode indicates either H869 or H868, then there's a good chance that the radio is secure hardware equipped.
As always, the best practice is to disassemble the radio and verify the physical presence of an encryption board, and look up the board part # to verify the crypto algo's loaded.