Cramped Install Space - Using 1 Speaker for a few Mobile?

This forum is dedicated to helping people with questions about installing radio equipment in vehicles. This can include antenna installs, electrical wiring questions/problems, and mounting systems. Pictures of installs are welcome.

Note: Discussions regarding lighting, sirens, and other equipment now has its own forum in the 'off-topic' section below.

Moderator: Queue Moderator

Post Reply
Ben10001
New User
Posts: 18
Joined: Mon Oct 15, 2007 7:21 pm
What radios do you own?: EX600, EX500, HT750 and more

Cramped Install Space - Using 1 Speaker for a few Mobile?

Post by Ben10001 »

I am starting an install in my trusty '00 Grand Cherokee which will consist of three mobiles in total. A spectra, a CDM and a dualband Yaesu.

For the challenge, being that this is a GC I thought up this brilliant idea that I am sure no one has ever thought of before! (big big wink), connecting all of the audio outputs into one single speaker, thus saving tons of space!

Now the idea may be absurd, but I am smarter then just twisting them all together and blowing all the sources (wink again), so what I was wondering is if this has ever been successfully tried before with some kind of mixer perhaps or something?

Using one speaker would make life MUCH easier!
Ben,
Jim202
Posts: 3610
Joined: Sun Sep 09, 2001 4:00 pm

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by Jim202 »

Ben10001 wrote:I am starting an install in my trusty '00 Grand Cherokee which will consist of three mobiles in total. A spectra, a CDM and a dualband Yaesu.

For the challenge, being that this is a GC I thought up this brilliant idea that I am sure no one has ever thought of before! (big big wink), connecting all of the audio outputs into one single speaker, thus saving tons of space!

Now the idea may be absurd, but I am smarter then just twisting them all together and blowing all the sources (wink again), so what I was wondering is if this has ever been successfully tried before with some kind of mixer perhaps or something?

Using one speaker would make life MUCH easier!



DO NOT GROUND EITHER OF THE MOTOROLA SPEAKER WIRES. With that said, on most Motorola radios, there is a DC bias on both speaker wires. Grounding either of the wires will result in damaging the audio output of the radio. It is never a good idea to just connect multiple speaker output wires together. You might get away with it on multiple scanners, but be very careful if your trying to do this on a two way communications radio.

It would be well worth your time to obtain a service manual of each of the radios you intend to do this with and check out how the audio output stages are wired.

I have 6 radios in my truck and each of them have their own speaker. If you look around, there is always room under the seats, up behind the dash and so on. If needed, you might try obtaining smaller speakers to take up less room.

Jim
tvsjr
Posts: 4118
Joined: Fri Nov 28, 2003 9:46 am

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by tvsjr »

The right solution is a speaker combiner... Fleet Radio Products made some for several years, but then disappeared. They now show up on eBay...
http://www.ebay.com/itm/4-CHANNEL-AUDIO ... 416947ec3d

Not the seller, just a happy customer... I'm running 3 in my current truck. No, they're not cheap.
User avatar
Tom in D.C.
Posts: 3859
Joined: Tue Sep 04, 2001 4:00 pm
What radios do you own?: Progreso soup can with CRT

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by Tom in D.C. »

$225 for a spec-grade combiner is a good buy compared to the bother of setting up your own small mixer-amplifier, and it'll save you a lot of space. One other supplier you might wish to check out is Radio Design Labs (RDL)) which makes a ton of small audio system interface devices. The RDL website for some reason does not have the "Stick-On" devices that are used for this kind of situation, but I found them at another site, which is, http://www.fullcompass.com/category/Rad ... dules.html
Tom in D.C.
In 1920, the U.S. Post Office Department ruled
that children may not be sent by parcel post.
motorola_otaku
Posts: 1854
Joined: Tue Jan 13, 2004 7:03 am

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by motorola_otaku »

tvsjr wrote:The right solution is a speaker combiner... Fleet Radio Products made some for several years, but then disappeared. They now show up on eBay...
http://www.ebay.com/itm/4-CHANNEL-AUDIO ... 416947ec3d

Not the seller, just a happy customer... I'm running 3 in my current truck. No, they're not cheap.
+1 for the Fleet Radio combiner (I run two.) The new manufacturer will sell direct if you don't want to deal with Ebay and Paypal: http://www.cmdcomm.com
User avatar
Wowbagger
Aeroflex
Posts: 1287
Joined: Tue Dec 10, 2002 10:46 am

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by Wowbagger »

Another suggestion:
1) Get some audio isolation transformers, such as this:
http://www.mouser.com/ProductDetail/Xic ... 2fC7J2U%3d
2) Connect secondary to radio.
3) Sum the primaries through one 10 kOhm resistor per transformer on one side, and wire the other side to a common point.
4) Connect one 100 Ohm resister from the summing node to the common point.
5) Feed into a cheap amp, such as this:
http://www.mcmelectronics.com/product/S ... -/50-10145
There! One speaker, many radios, each isolated.
This is my opinion, not Aeroflex's.

I WILL NOT give you proprietary information. I make too much money to jeopardize my job.

I AM NOT the Service department: You want official info, manuals, service info, parts, calibration, etc., contact Aeroflex directly, please.
AEC
No Longer Registered
Posts: 1889
Joined: Wed Dec 22, 2004 7:56 pm

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by AEC »

Here's a simple and cheap method to use multi-radios with 1 speaker, but this method uses the vehicle's stereo speakers (I do not listen to THAT radio), so i simply disable the factory junk and run each radio to a different speaker, the main is feeding the dash left speaker, the secondary feeds the dash right speaker.
Rear speakers used for hammy things, same scenario, just a little higher audio level settings.

NOT high tech and certainly NOT for those that have that noise box running either, but I hate commercials and this helps me avoid them even better than ever!

Of course, every stereo system demands checking speaker impedances, so a caveat is implied.
Isolation transformers might need to be used, as resistors for summing lines, but usually not if running single radios, single speakers.
Always match impedances to your radios, and do NOT ground those 'Trac speaker outputs, or the CDMs, Etc...Check the schematics to see WHAT you can do with your radio's speaker output leads first!
User avatar
candrist
Posts: 99
Joined: Thu Jun 16, 2005 6:56 am
What radios do you own?: XPR5550/7550, MTS2000 800MHz

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by candrist »

There are also less expensive audio combiners on ebay.

http://www.ebay.com/itm/RDL-Stick-on-mo ... 2c680de58b
motorola_otaku
Posts: 1854
Joined: Tue Jan 13, 2004 7:03 am

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by motorola_otaku »

One thing to note with the RDL Stick-On combiners is that they don't have internal speaker-level amplifiers or per-channel level adjustment. And if you go shopping for an amplified speaker to use with one, do not get the Workman amplified speakers.. they are complete and total garbage.
SlimBob
Posts: 911
Joined: Thu Dec 18, 2003 11:38 am

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by SlimBob »

Take four speakers, take two out of the boxes and mount them to the faces of the other two. Point both assembled pairs at each other so the exposed magnets are facing each other. Now take thick plastic and form a horn out of it to wrap around the now "block" of four speakers and put the audio waves toward the occupants of the vehicle...
MP 6.7
Posts: 109
Joined: Mon Aug 22, 2005 11:00 am
What radios do you own?: Spectra, Maxtracs, MT2k, GP300

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by MP 6.7 »

SlimBob wrote:Take four speakers, take two out of the boxes and mount them to the faces of the other two. Point both assembled pairs at each other so the exposed magnets are facing each other. Now take thick plastic and form a horn out of it to wrap around the now "block" of four speakers and put the audio waves toward the occupants of the vehicle...
As an audio engineer, this makes me cringe......

Should work though for a 2-way. Not a whole lot of worry about coverage pattern and phase coherency here :lol:
Dale
KE7CEU
Current radios
Mobiles: 3x D43 A7 Spectras, T83 A9 Spectra, 2x KLM and 2x KLN MCS2000's, D43 Maxtrac 32ch, D35 Maxtrac 6ch modded for 896MHz receive, M33 M1225 4ch, Lowband Maratrac on 6 meters
Portables: 2x VHF GP300, VHF P110, UHF P110, VHF A7 MT2000
SlimBob
Posts: 911
Joined: Thu Dec 18, 2003 11:38 am

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by SlimBob »

That and less than 35dB S/N ratio in a car due to road, wind, and other noises...
Last edited by SlimBob on Wed Oct 31, 2012 11:43 am, edited 1 time in total.
User avatar
Tom in D.C.
Posts: 3859
Joined: Tue Sep 04, 2001 4:00 pm
What radios do you own?: Progreso soup can with CRT

Re: Cramped Install Space - Using 1 Speaker for a few Mobile

Post by Tom in D.C. »

Universal Radio carries a small speaker that is tradenamed "Altec" which is about 2X2X2 inches and has very good
communications quality audio. Due to the small size, these units can usually be fitted into very small spaces in the car
and you would not need to worry about any audio combining questions.
Tom in D.C.
In 1920, the U.S. Post Office Department ruled
that children may not be sent by parcel post.
Post Reply

Return to “Vehicle Radio Installs”