Town & Country install

This forum is dedicated to helping people with questions about installing radio equipment in vehicles. This can include antenna installs, electrical wiring questions/problems, and mounting systems. Pictures of installs are welcome.

Note: Discussions regarding lighting, sirens, and other equipment now has its own forum in the 'off-topic' section below.

Moderator: Queue Moderator

Post Reply
User avatar
arlojanis
Posts: 995
Joined: Mon Jan 28, 2002 4:00 pm

Town & Country install

Post by arlojanis »

Where is the best place to make a hole to pass thru firewall in a new Chrysler town & country van?
"The world runs on radio."
User avatar
KC9MDQ
Posts: 44
Joined: Fri Jul 18, 2014 3:50 pm
What radios do you own?: Motorola,Vertex, Kenwood

Re: Town & Country install

Post by KC9MDQ »

There should be a large grommet on the driver's side of the firewall, that's where I ran my coax and the power lead for the MaxTrac through.
Powered by Yoyodyne Propulsion Systems
User avatar
KC9MDQ
Posts: 44
Joined: Fri Jul 18, 2014 3:50 pm
What radios do you own?: Motorola,Vertex, Kenwood

Re: Town & Country install

Post by KC9MDQ »

My T&C is a 2008, and I mounted my 32 channel MaxTrac in the cubby directly below the HVAC controls. I had to remove the entire center stack and unbolt the cubby from front face plat, after that it slid right in. If memory serves, the 2011 and up T&C's ( and Caravan's ) relocated the HVAC to a slightly different location, but I believe the grommet is in the same location. I'll try to post a picture of the grommet location in my van, that should at least give you a frame of reference.
Powered by Yoyodyne Propulsion Systems
Post Reply

Return to “Vehicle Radio Installs”