I just programmed an LS+ with conventional channels. Some of them receive and sound fine. Others don't sound unless the monitor/sticky monitor is active.
In the global configuration I have monitor set to silent rather than open squelch (IIRC). In the channel specific profikes, I'm used to seeing the AND/OR options, but they're grayed out.
Thanks!
HT1250 CPS Question
Moderator: Queue Moderator
- SteveC0625
- Posts: 467
- Joined: Sat Jan 01, 2011 9:46 am
- What radios do you own?: CDM's, CP's, CM's, and more
Re: HT1250 CPS Question
Radio Configuration --> Monitor tab: Monitor Type should not matter. I have one radio set to Silent and everything works fine. I have another that is set to Open Squelch, and it works just as well (that one came to me like that and I did not mess with the setting.)shael wrote:I just programmed an LS+ with conventional channels. Some of them receive and sound fine. Others don't sound unless the monitor/sticky monitor is active.
In the global configuration I have monitor set to silent rather than open squelch (IIRC). In the channel specific profiles, I'm used to seeing the AND/OR options, but they're grayed out.
Thanks!
The AND/OR option only appears if you assign one of the signaling systems to the Rx side of the personality. AND is only needed when you have a signaling system muting the radio in addition to carrier squelch.
Re: HT1250 CPS Question
Thanks for the detailed response. What would you recommend I do in this Case to resolve the issue? I could assign a signaling system, literally make something up. I dont need alerting here, just want to hear the channels properly.
- SteveC0625
- Posts: 467
- Joined: Sat Jan 01, 2011 9:46 am
- What radios do you own?: CDM's, CP's, CM's, and more
Re: HT1250 CPS Question
Without seeing the codeplug, I have no way of understanding the settings enough to help you. PM coming at you.shael wrote:Thanks for the detailed response. What would you recommend I do in this Case to resolve the issue? I could assign a signaling system, literally make something up. I dont need alerting here, just want to hear the channels properly.
Re: HT1250 CPS Question
It's sounds like shael's isn't decoding PL/DPL correctly *OR* the wrong values are plugged in *OR* the station he's listening too doesn't actually transmit PL.
- SteveC0625
- Posts: 467
- Joined: Sat Jan 01, 2011 9:46 am
- What radios do you own?: CDM's, CP's, CM's, and more
Re: HT1250 CPS Question
Agree. I asked him to send the codeplug to me. I'll see if anything jumps out as a problem.Bill_G wrote:It's sounds like shael's isn't decoding PL/DPL correctly *OR* the wrong values are plugged in *OR* the station he's listening too doesn't actually transmit PL.
Re: HT1250 CPS Question
You both are so generous, thank you! I'll gladly share the CPG when I'm home this evening.