XTS 3000 Scan Problem

radmano · Post by **radmano** » Wed Jan 15, 2003 8:24 pm

Have 2 zones programmed, each consists of all conventional channels. Have 2 scan lists, first of which consists of all channels in zone 1, while second consists of all channels in zone 2. A-B-C switch has B programmed for B to scan. It works fine for Zone 1. When I switch to Zone 2 however, it doesn't scan. Parameters selected for scan lists are identicle. Any ideas what's wrong? Thank you.

Post by **wavetar** » Thu Jan 16, 2003 12:49 pm

Sounds like you have the scan list selection set to "1", or possibly "none" in your Zone 2 conventional personalities. Every personality needs to be told which scan list to reference. Switch it to "2" and you should be set.

Todd

radmano · Post by **radmano** » Thu Jan 16, 2003 7:16 pm

I forgot that you had to select a scan list under each personality- It did this automatically for the first Scanlist. Thank you

XTS 3000 Scan Problem

XTS 3000 Scan Problem

Thanks- That was the Problem