Maratrac TPL Question

trzenk · Post by **trzenk** » Thu Dec 06, 2001 10:11 pm

We have recently installed new bases with coded scuelch enabled. All of the radios have been reprogramed to include a TPL of 192.8, however i have not been able to get all of the maratracs to work on the new system, they transmitt but it dose not open the squelch on the repeater or the base. but other units with open rx hear them just fine. i have tried cloning other codeplugs from maratracs that work on the system to the 3 problem radios with no luck. Any Ideas?

raymond345 · Post by **raymond345** » Fri Dec 07, 2001 2:00 am

Hi there. when u use a service monitor
the tpl tones are + or - 2% if tone is not
correct then no signal.The tone cirt.
many not be in spec.This has been a problem.
It has to be serviced on the bench.
Raymond