XTS3500 Program Cable - Pin Addition/Removal

[code3media]

OK guys, I need some help. I would like to make a programming cable out of a busted speaker mic. Question is how do I remove the plastic cover so I can get to the back of the pins?

[Code636]

first, where the earpiece adapter is, unscrew the retaining ring off of it. 2) the conical hard plastic cover which cable runs through, uncsrew it off and pull up, small orange o-ring under it. 3) pop the side cover off that covers the pins, push down on cable and...ta-da!! its out..

Scott

[code3media]

thanks