sbaer III question

olderookie · Post by **olderookie** » Thu Jul 10, 2003 9:52 am

I know it has been said but I can not find it how do you put a saber into test mode. some thing about pushing the right button as you turn it on?

thanks

RKG · Post by **RKG** » Thu Jul 10, 2003 11:15 am

For Systems Sabers, hold in the top three (red) buttons while powering up. I think, but am not positive, that it is same for original Sabers.

JohnDo · Post by **JohnDo** » Thu Jul 10, 2003 3:21 pm

Yes its the same for saber III

JK

kc2dla · Post by **kc2dla** » Thu Jul 10, 2003 7:37 pm

when I do this on my secure Saber III it displays the alphanumeric row completely solid and the secure indicator appears (slashed circle). No buttons function or change the display. Anything else I can make it do with this service/test mode?

MT2000 man · Post by **MT2000 man** » Thu Jul 10, 2003 8:17 pm

I believe you have to press the monitor button (top "rubber" button on the side of the radio) 5 times rapidly while it powers up.

I think.

Let me know if that works.

Mike
On Edit -
I just tried that with my MT2000, and it worked. It displayed the Model #, did an RF test, and CH test. When I get my saber III back Friday I'll see if it does the same.