Looking to clear the 8 dots on CC2 clock...

Paramedic606 · Post by **Paramedic606** » Wed Feb 19, 2003 9:07 pm

Our CC-II console threw an error some time ago and has since shown a red dot after each LED (8 in all). I know there is a way to acknowledge and clear this but I am not sure what...any help would be appreciated. Thanks!

-Paul

P.S.- It's getting late, the clock reads 0.0..0.6..3.2. !

RocketNJ · Post by **RocketNJ** » Wed Feb 19, 2003 9:13 pm

I believe it is hold the up arrow (shift) and hit 1 2. Then hold up arrow and hit A B

George

The Pager Geek · Post by **The Pager Geek** » Thu Feb 20, 2003 3:15 pm

I would wonder what caused the problem before you erase the log....

tpg

RocketNJ · Post by **RocketNJ** » Thu Feb 20, 2003 3:39 pm

Clearing the dots does not clear the log. The first time you connect to the RS232 board above the OMI/TOMI it should spit out the diags.

He can do diag 13 on each TDM to see if a particular board has faild and stayed failed.

George