Page 1 of 1
Looking to clear the 8 dots on CC2 clock...
Posted: Wed Feb 19, 2003 9:07 pm
by Paramedic606
Our CC-II console threw an error some time ago and has since shown a red dot after each LED (8 in all). I know there is a way to acknowledge and clear this but I am not sure what...any help would be appreciated. Thanks!
-Paul
P.S.- It's getting late, the clock reads 0.0..0.6..3.2. !
Posted: Wed Feb 19, 2003 9:13 pm
by RocketNJ
I believe it is hold the up arrow (shift) and hit 1 2. Then hold up arrow and hit A B
George
Posted: Thu Feb 20, 2003 3:15 pm
by The Pager Geek
I would wonder what caused the problem before you erase the log....
tpg
Posted: Thu Feb 20, 2003 3:39 pm
by RocketNJ
Clearing the dots does not clear the log. The first time you connect to the RS232 board above the OMI/TOMI it should spit out the diags.
He can do diag 13 on each TDM to see if a particular board has faild and stayed failed.
George