Maratrac and gm300 cable

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
ICEMANTIM
Posts: 120
Joined: Mon Oct 29, 2001 4:00 pm

Post by ICEMANTIM »

Hello i have a question about the maratrac and gm300. On the batlabs site it says that the programing cable has a 25 pin contector on one end and a rj45 on the other. I received a cable with my rib box for the gm300's that has a rj45 on both ends, and it works fine. The question is can i use the cable with the two rj45's for the Maratrac. Thanks
Will
Posts: 6823
Joined: Tue Sep 04, 2001 4:00 pm

Post by Will »

Some non Motorola RIBs had the RJ45 female connector on them. So the RJ45 male to male cable is used with them to program mobiles.
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”